Q-See QT528 Manual do Utilizador descarregar pdf (Página 22)

42 43

CHAPTER 7 REMOTE SURVEILLANCE

This DVR can be accessed remotely via a connected network and over the Internet.

7.1 NETWORK ACCESS

Accessing the DVR from a computer or computers attached to the same router as the DVR

requires setting up either DHCP or Static IP only. This is conﬁgured in the NETWORK setting.

You will be accessing the DVR by entering the IP address obtained during this setup into an

Internet Explorer browser window just as if you were opening a web page.

Once you have conﬁgured your NETWORK settings using DHCP or Static IP following the

instructions below, you may skip to Section 7.5 “Setting up Internet Explorer.”

7.2 REMOTE (INTERNET) ACCESS

There are three methods you can use to set up the DVR to be accessed remotely over the

internet for viewing on mobile devices and computers not on your network; DHCP, Static IP,

and PPPoE. You will also need to set up Port Forwarding (See Section 7.3).

DHCP

Most routers are factory conﬁgured to use DHCP.

DHCP involves having your router assign an IP address to the DVR on the network.

REMOTE SURVEILLANCE

CHAPTER 7

PICTURE 7-1

STEP 1. Select the Setup icon in the

Main Menu (Red Box in Picture

7-1)

STEP 2. Select the Network icon (Red

box in Picture 7-2)

PICTURE 7-2

STEP 3. Check the box after Obtain an

IP address automatically (Red Box

in Picture 7-3)

STEP 4. Click the Test button (Green

Box in Picture 7-3)

STEP 5. After receiving the OK message

in the lower left-hand corner of the

screen, click the Apply button to

save the IP address and then exit the

window.

PICTURE 7-3

You have now completed DHCP setup for network access, but we suggest taking the

following, additional, steps in order ensure a stable connection by preventing the router from

assigning a new address to the DVR at a later date.

STEP 6. Upon return to the Main Menu, click on the Information icon (Green box in

Picture 7-1) and write down the IP address.

STEP 7. Return to the Network window (See steps 1 and 2) and write your new IP

address in the IP Address ﬁeld.

STEP 8. Deselect the “Obtain an IP address automatically” checkbox, select Apply

before exiting the window.

The IP address will be used to forward ports 80 and 6036 on the router when setting up

access to the DVR from remote computers.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 49 50

Comentários a estes Manuais

Sem comentários

Q-See QT528 Manual do Utilizador Página 22

Comentários a estes Manuais

Manuais e produtos relacionados com Gravadores de vídeo digitais (DVR) Q-See QT528