Q-see Computer Hardware Manual do Utilizador descarregar pdf (Página 42)

Error! Use the Home tab to apply

标题

1 to the text that you want to

appear here. Error! Use the Home

tab to apply

标题

1 to the text that

you want to appear here.

SuperDVR & H.264 Series Cards

User Manual

DSCP, DH-SD, Lilian, Minking, Neon, PelcoD, PelcoP, Star, VIDO, VISCA

3. Address

Communication address of P.T.Z device (ID number)

4.7.2 Serial Ports Setup

Users should first enable the P.T.Z control function of a certain camera and

select a port number in P.T.Z Protocol Setup (refer to Figure4-18), and then

set corresponding parameters in the area below:

Figure4-19 P.T.Z Serial Port Setup

1. Port

Users can set port number.

2. Baud Rate

Set P.T.Z device Baud Rate to match setting on camera, default value is 9600.

3. Data Bits

Default value is 8.

4. Parity

Odd and even parity bit, default None.

5. Stop Bits

Default value is 1.

NOTICE: Users should look at the control board of the P.T.Z device

and get the Baud Rate, Protocol, and Address first, then enter the

same values into the SuperDVR program.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 103 104

Sem comentários

Q-see Computer Hardware Manual do Utilizador Página 42